Common Problems We See
Not heating or cooling right
Sometimes that’s a low refrigerant charge, a coil that’s caked with dirt, or a reversing valve that’s given up. We test pressures, clean what needs cleaning, and change only what’s bad.
Water coming out inside
That’s usually a clogged drain line or a cracked drain pan. We clear the blockage, make sure the line drains downhill like it should, and seal the wall sleeve so water stays outside.
Electrical issues
If the breaker keeps tripping or the unit’s completely dead, we check voltage, wiring, and control boards before we decide a part needs replacing.
Poor airflow or odd noises
Dirty filters, fans out of balance, or worn bearings can cause both. We clean, balance, and lubricate moving parts so the system runs quieter and pushes air like it should.
Call us at (508) 310-0955 if your system’s acting up—we’ll get it sorted.
Call (508) 310-0955
Discuss your project with our experts and receive a same-day estimate window, so you’ll know exactly what to expect before we begin.
Call Now
Mini Split Systems We Work On
We handle single-zone wall units in bedrooms and offices, multi-zone setups serving the whole house, and floor or ceiling cassettes tucked away behind panels.
Single-zone wall units
These are common in bedrooms, home offices, or small additions. They need regular filter cleaning and the occasional refrigerant check to keep them running right.
Multi-zone systems
These feed several rooms from one outdoor unit. If one zone quits, it usually takes some refrigerant balancing or control board work to get everything back in sync.
Floor and ceiling cassettes
We service these hidden units by opening up access panels, cleaning the drain pans, and making sure the fans and filters are in good shape.
Cold-climate heat pumps
Built to run all year, these can ice up or stall in the middle of winter. We check the defrost cycle, sensors, and refrigerant levels to keep them moving heat when it’s frigid out.
How We Go About Repairs
- Look it over – We check filters, coils, and drains, then run it in heat and cool to see what it’s doing.
- Test it – Gauges and a meter tell us refrigerant levels, electrical readings, and where the fault really is.
- Fix it – Could be flushing a drain, cleaning coils, swapping a sensor, or adding refrigerant.
- Double-check – We make sure temperatures, airflow, and electrical readings are back where they should be.
We leave you knowing exactly what we did and what to watch for next.
Areas We Serve in Upton, mA
Area | Notes |
Upton | Homes near Upton State Forest and along Route 140 |
Milford | Capes, ranches, and updated colonials with ductless systems |
Mendon | Clearing drains and refrigerant work for all mini split types |
Bellingham | Airflow and noise fixes in established neighborhoods |
Uxbridge | Cold-climate heat pump checks for winter reliability |
If you’re in Worcester County but don’t see your town, call us—chances are we’re nearby.
Keeping Your Mini Split Running
A ductless system will serve you for years if you give it a little attention. We tell our customers to clean or replace the filters every month during heavy use.
That keeps dust and pet hair from choking the airflow and overworking the fan motor.
Twice a year, it’s smart to rinse the indoor coil and flush the drain line. In Upton, spring pollen and fall leaves are the two big troublemakers. If they build up, you’ll see reduced cooling and—worse—water dripping inside.
Once a year, have us check the refrigerant charge, test the electrical components, and inspect the outdoor unit for signs of wear. A quick tune-up in the shoulder seasons often saves you from a breakdown when it’s sweltering or freezing.
FAQs Common Repair Questions
The top issues we see are low refrigerant from small leaks, filters clogged with dust, drain lines blocked by debris, failed sensors, and control boards that have burned out.
If water is coming from the indoor unit, the drain line is probably clogged or pitched the wrong way. We’ll clear the blockage, re-level the unit, and make sure the pan drains the way it should.
Don’t wait if you notice weak heating or cooling, new or louder noises, water where it shouldn’t be, or an error code on the display. Problems caught early are almost always cheaper to fix.
Turn the unit off at the remote, wait three to five minutes, then power it back on. You can also shut it off at the breaker for the same amount of time. If the error or issue comes right back, it’s time for a service visit.
Licensing
We’re licensed in Massachusetts for refrigeration work—License #11040. If a repair calls for electrical work, we bring in a licensed electrician. We also handle refrigerants by the book, following state and federal rules.